Roof and fence work in League City since 2009 · Call (713) 828-2551
A Honesty Roofing installs new roofs in League City on new homes, additions, patio covers and detached garages. Vance builds the roof in the right order: decking checked, drip edge, synthetic underlayment, ice and water in the valleys, flashing in metal, architectural shingles, and a ridge vent sized for Houston heat. Free quote, owner on the job.
A new roof installation is different from a replacement. There is nothing to tear off. The framer hands us a bare deck, or an addition or patio cover that has to tie into a roof that is already there, and the job comes down to doing every layer in the right order. Skip one and the roof leaks the first time a Gulf storm blows rain sideways.
Here is the order Vance builds in. First the deck: we walk every sheet, check the nailing and mark any soft or swollen OSB before it gets covered. Then drip edge at the eaves, synthetic underlayment, and ice and water membrane in every valley and around every pipe, vent and skylight. Step flashing goes in course by course where the roof meets a wall, counterflashing into the mortar where it meets brick. Then starter strip, the shingle field, and hips and ridges capped last, with the ridge vent slot cut before the cap goes on.
Most of our new roof work in League City is additions, patio covers and detached garages in neighborhoods like Tuscan Lakes, Westover Park and Magnolia Creek, plus new builds, barns and shops out toward Santa Fe. A small roof gets the same layers as a whole house.
If your current roof is at the end of its life, our roof replacement page walks through the tear off and what drives price. One bad spot on a sound roof is a roof repair, not a new roof. Buying a new build? Book a roof inspection before you close. And if the project includes a yard, we build cedar fences too.

Architectural shingles, almost every time. They are thicker than three tab, carry a higher wind rating, and hide small deck imperfections better. On the Gulf Coast the wind rating is the number that matters. Ask for a shingle rated for high wind and make sure it is nailed to the high wind pattern, which is more nails per shingle than the standard four. That is what keeps shingles on when a storm like Beryl comes through. Color matters more here than up north: a lighter shingle runs cooler in August, and algae resistant granules keep black streaks off a north facing slope in our humidity. Impact resistant shingles cost more and hold up better in spring hail, so ask your insurance agent whether they discount for them. Vance brings samples and quotes the grades side by side.
Ventilation is the part builders cut corners on and the part that shortens a roof the most. A closed attic in League City gets hot enough to cook the shingles from underneath and holds moisture against the deck. The fix is balanced airflow: intake at the soffits, exhaust at the ridge, sized to the attic. On a new roof we cut a continuous ridge vent and confirm the soffit vents are actually open behind the fascia, because a ridge vent with blocked soffits pulls nothing. We do not mix a ridge vent with box vents or a powered fan on the same slope. Mixed exhaust short circuits the airflow and can pull rain in at the ridge. A bath fan or dryer vent through the roof gets its own flashed cap, never dumped into the attic.
On new construction and additions, timing is the whole job. Vance talks to the builder or framer before the deck goes on so the roof is dried in the day the sheathing is finished, not a week later after rain has soaked the OSB. The order we ask for: deck nailed off, plumbing vents and HVAC penetrations cut and stubbed up so we flash them once, then underlayment and shingles. Step flashing at walls goes in with the roof so the siding or brick crew works over it, not under it. Where a patio cover ties into the house we flash the wall and add a kick out flashing at the bottom so water does not run behind the siding. On additions the new valley is cut into the existing roof and woven, and the shingle is matched as closely as the old color allows.
Call Vance, or send the form and he will call you back to set up a look at the roof.
📞 Call (713) 828-2551Your details go to Vance and nowhere else.
Yes. A patio cover, a detached garage or a shed roof is the same roof as the house, just smaller, and it fails the same way. We see patio covers with no drip edge, no underlayment, shingles nailed straight to the deck, and a wall joint sealed with a bead of caulk. They leak early and rot the ledger board. Every small roof we install gets the same drip edge, underlayment, metal flashing and venting as the house. Done right it costs a little more up front and does not have to be redone.
Deck check, drip edge, synthetic underlayment, ice and water in the valleys, metal flashing, high wind nailing, ridge vent. Vance does not skip a layer to hit a number, and he will show you each one before the next covers it.
Balanced intake and exhaust sized for the attic, a continuous ridge vent, and no mixed exhaust on the same slope. Houston heat and humidity attack a roof from underneath, and a properly vented attic is the cheapest way to make shingles last.
Vance coordinates with the framer so the deck is dried in the day it is finished, and he flashes every penetration once, after the trades have cut them. Builders get a straight answer on timing and a roofer who shows up on the day he said.
A patio cover, a garage or a shop in Santa Fe gets the same underlayment, flashing and venting as a house. Vance quotes it, runs it and sweeps the yard with a magnet for nails afterward. Same crew, same materials, whatever the size.
These are real Google reviews, quoted as written. Read all 54 on our Google Business Profile.
“Five stars for Vance! He went above and beyond to help me out today. He was incredibly patient, took the time to understand my concerns, and methodically troubleshot every question I had until we got it sorted. It's rare to find that level of dedication and customer service these days. Thanks, Vance!”
Travis M., Google
“We had two excellent experiences with Vance's company this week, both related to our roof. Mike did a beautiful job on the vent lines. He went the extra mile and did a thorough roof and fireplace chimney inspection.”
Clayton B., Google
“A Honesty Roofing did a great job making the repairs we needed to sell our home. We were never pushed for things we didn't need. I would highly recommend.”
Diana B., Google
A Honesty Roofing works from League City across Galveston County and the Clear Lake side of Harris County. If your town is on this list, Vance has most likely been on a roof near you.
Our shop is at 2125 Boden St, League City, TX 77573. Directions from nearby landmarks:
Call, and Vance will look at the roof with you and tell you plainly whether it needs a repair or a replacement. You get a written price before anyone climbs a ladder.